To get a Don Toliver-style vocal in Logic Pro X or GarageBand, record a melodic lead in key, set Pitch Correction to a fast response, lift the presence around 2 to 4 kHz, and compress at about 4:1. Then add wide doubles, ad-libs with delay throws, and a medium reverb.
This guide gives stock-plugin starting settings for that sound, as listeners usually describe it: melodic, tuned, bright and wide, with a trap and R&B feel. We use that description as reference listening only. We do not know the artist's real plugins, settings or studio chain, so treat every value as a starting point and adjust by ear. To load a finished chain, see our Logic Pro vocal presets or our GarageBand vocal presets.
Thir13een is not affiliated with, endorsed by or connected to Don Toliver. "Don Toliver-style" names a sound we aim to approximate, nothing more.
What does a Don Toliver-style vocal sound like?
People who describe this sound often mention melody and polish. The lead is clearly tuned, with a bright, slightly nasal presence that cuts through a dark beat. Doubles spread the voice wide, and echoes trail off the ends of phrases.
Most of that comes from the writing and the performance. Pick a key before you record, and sing the melody with clear note targets. Tuning works best on a take that is already close to the notes. A chain adds the sheen, but it cannot add a melody.
What are good starting settings for a melodic, tuned trap vocal?
Use this table on a clean, dry vocal. It uses stock plugins, so it works in Logic Pro X and in GarageBand on Mac. Logic Pro names come first. Change one setting at a time and judge it against the full beat.
| Stage | Plugin and parameter | Starting value | Why |
|---|---|---|---|
| EQ | Channel EQ, high-pass | About 90 to 120 Hz | Clears rumble and leaves room for the 808 |
| EQ | Channel EQ, low mids | Cut 1 to 2 dB around 300 to 400 Hz | Keeps a bright vocal clean |
| EQ | Channel EQ, presence | Boost 2 to 3 dB around 2 to 4 kHz | Brings the bright, forward tone |
| EQ | Channel EQ, air | Shelf 2 to 3 dB above 10 kHz | Adds shine to the tuned notes |
| Pitch | Logic: Pitch Correction, Response and Limit to Key. GarageBand: Pitch Correction slider with Limit to Key | Fast response; slider near 100 percent | Gives the clearly tuned sound. Set the key and scale first |
| Compressor | Ratio and gain reduction | 4:1, 4 to 6 dB of gain reduction | Keeps the melody steady over the beat |
| Compressor | Attack / Release | Attack 5 to 15 ms, Release 50 to 90 ms | Keeps the front of each note clear |
| Saturation | Logic: ChromaGlow or Overdrive, low. GarageBand: skip, or use a small Overdrive amount | Drive low; mix well under half | Adds body to a bright vocal |
| De-esser | DeEsser 2 (Logic). In GarageBand, a narrow Channel EQ cut near 6 to 8 kHz | Reduce 3 to 5 dB | Controls the "s" sounds that tuning and air boost bring out |
| Delay | Tape Delay (Logic) or Echo (GarageBand), on a send | Eighth note, feedback 20 to 30 percent, filter the low end | Gives the trailing echoes on phrase ends |
| Reverb | ChromaVerb (Logic) or Reverb send (GarageBand) | ChromaVerb: Plate, 1.2 to 1.8 seconds, send low to moderate | Adds width and depth without a wash |
Want this chain pre-built? A preset loads a chain like this in one click, and you tune it to your voice. We do not sell one made for this sound. Browse the Logic Pro vocal presets or the GarageBand vocal presets, or download Toronto Warmth, our free Logic Pro X preset.
If your Logic version has no ChromaGlow, use Overdrive or skip the saturation stage. For a full frequency guide, see the vocal EQ cheat sheet.
How do I add wide doubles and delay throws?
- Set the project key. Record the lead and tune it.
- Record two doubles of the hook, one for each side. Match the lead's timing.
- Pan the doubles 50 to 80 percent left and right, and set them 6 to 10 dB under the lead.
- Record ad-libs on their own track. Keep them short and put them at the ends of lines.
- Automate the delay send up on the last word of a line, then bring it back down. This makes a delay throw.
- Keep the verses narrower and bring in the full width on the hook.
How do I keep the effects wide without losing the lead?
Keep the lead near the center, with the delay and reverb returns carrying the width. Cut the returns below about 300 Hz so the bass stays clean. If the doubles get in the way of the words, lower them by 2 dB before you change the reverb. Check the mix in mono once. If the lead drops out, shift the doubles closer to the center.
How do I do this in GarageBand?
On Mac, select the vocal track, open the Smart Controls, and add Channel EQ and Compressor in the Plug-ins section. Use the Pitch Correction slider with Limit to Key in the audio region editor, and the Echo and Reverb sends in the track controls. GarageBand has no DeEsser plugin, so use the narrow Channel EQ cut from the table. Record each double and ad-lib on its own track. iOS layouts differ, so we list no iOS-only values. For the full workflow, see how to mix vocals in GarageBand.
Stock plugins or a preset: which should I use?
The stock chain above is free and enough for a finished mix. A preset saves time, because the chain is already built and you tune it to your voice. We do not sell a preset made for this sound, and we do not claim any preset reproduces an artist's voice. A preset is a starting chain, nothing more.
If you use GarageBand, browse the GarageBand vocal presets collection. If you use Logic Pro X, browse the Logic Pro vocal presets collection. You can also download Toronto Warmth, our free preset for Logic Pro X. It is built for Logic Pro X, so it only helps if you also use Logic.
More vocal style guides
- Vocal sounds by artist: every style guide in one place
- Travis Scott-style vocals in Logic Pro and GarageBand
- Future-style vocals in Logic Pro and GarageBand
- Drake-style vocals in Logic Pro and GarageBand
FAQ
Is there a free Don Toliver-style vocal preset?
We do not sell a preset made for this sound. Our free preset, Toronto Warmth, is for Logic Pro X and is not built for it. The stock chain on this page is free in both apps.
How do I get a Don Toliver-style vocal in GarageBand?
Set the project key, record a clear take, add Channel EQ and Compressor, and push the Pitch Correction slider high with Limit to Key. Add an Echo send, and record doubles on separate tracks.
Is this made by or endorsed by Don Toliver?
No. Thir13een is not affiliated with, endorsed by or connected to Don Toliver.